Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Andyco

Pages: [1]
1
Frame, Tank, Seat, Controls, Etc / Hand controls
« on: January 28, 2015, 08:28:20 AM »
Am now a proud owner of a '43 G model Simplex (I think). Its a duplicate of this picture.  http://www.surfacezero.com/g503/data/3164/Simplex_Canadian_use.jpg.... (Someday I'll learn how to put a pic in message box)...... There are three differences though. My kickstand is in back of the left foot rest, It does have a package rack in the rear and it has a front brake. The brake has me puzzled. If I took the left hand lever and hooked it up to the front brake I wouldn't have a comp release. I'm thinking of using the right lever as a comp release and the left lever as the front brake and installing a twist grip throttle. Did the '43 come with a front brake and if so how were the controls configured? I purchased a couple of throttles at the local motorcycle swap meet last Sun. They're probably from a mini bike or 50's or 60's motorcycles. I'd like to remain as close to stock as possible but I'm not obsessive about it.  I've been lurking this web site for quite a while and find it a font of info. Everyone is stand up. Thanks

2
Introductions / New Guy (FNG)
« on: January 28, 2015, 07:57:53 AM »
Hello from SoCal. I've been looking for a Servi Cycle for around 2 1/2 years but all were out of my $ range. Finally found one that wouldn't bust the bank. Its a '43 G model that at one point in its life was a water department vehicle at Norfolk Naval Air Station in Virginia. I have some Q's about the controls and will post in appropriate area.

Pages: [1]