Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - lamptester55

Pages: [1]
1
Wheels & Tires / 1939-40 Servi Cycle brake and throttle lever
« on: December 02, 2014, 09:51:03 AM »
I need a photograph of a 1939-40 brake lever and throttle lever.
Or original supplier name.
I have one brake lever, but have never found a close match. So I am not sure what was on the bike. The lever that I have seems a bit beefier than bicycle levers.
Any help greatly appreciated.

2
Engine & Transmission / Tillotson carb 1939 rebuild kit
« on: October 19, 2013, 07:51:11 AM »
Where does one find a rebuild kit for a vintage 1939 Tillotson carb?
The carbs themselves are occasionally available on Ebay, but they probably need rebuilding, float valve etc..
The body of the Tillotson carb that I have is in poor condition.

3
Restoration Projects / 1939 ServiGlide
« on: September 09, 2013, 03:08:30 PM »
Reference 1939 ServiGlide:
Turned over the engine with a drill and it had spark. I had been told not to expect any spark because of its age. Next, I installed a lawnmower carburetor of unknown origin. I then turned the engine over with a drill and it quit running after the primer gas was used up. Positive thing is that the engine fired up and got a few revolutions. Gary Wollard had told me several years back that I should obtain a Carter Model N carburetor, which I had done. I then installed the Carter carburetor, gave it a shot of primer gas and cranked it over with a drill. The engine fired and ran like a charm.

4
1940 ServiCycle

Part Number number 493 rear wheel pully clips

I need a photo of a rear wheel pully clip taken with a ruler so that I can judge the size. Also the approximate thickness of the clip.
or a brief sketch with dimensions
or a known source to purchase some.

Thanks in advance.

I checked Workman Cycle and could not locate that part or part number

Pages: [1]