« previous next »
Pages: [1]   Go Down

Author Topic: Difficulty in getting back to neutral  (Read 1789 times)

CLWebster

  • Newbie
  • *
  • Posts: 11
    • View Profile
    • Email
Difficulty in getting back to neutral
« on: May 21, 2012, 05:51:55 AM »
Finally got the new carb fairly well adjusted and engine running ok again. Actually took a ride on Sunday. However, now I cannot get the bike back into neutral via the normal procedures, i.e., holding clutch pedal down and rolling bike back and forth.
Suggestions please!
CLWebster
Logged

Mike Sal

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1204
    • View Profile
    • Email
Re: Difficulty in getting back to neutral
« Reply #1 on: May 21, 2012, 10:19:54 AM »
Are you using the correct type belts (cogged)?  Is there enough lube on the cross shaft (that the pulleys slide back & forth on)?  If you shut the motor off & seek neutral, does it act normal?
Mike Sal
Logged

CLWebster

  • Newbie
  • *
  • Posts: 11
    • View Profile
    • Email
Re: Difficulty in getting back to neutral
« Reply #2 on: May 21, 2012, 01:03:11 PM »
The belts may be the problem. They have been loosing teeth!
Logged
Pages: [1]   Go Up
« previous next »