General Category => Simplexes with Non-Original Engines => Topic started by: razerface on December 25, 2022, 07:50:04 AM
-
I have the gs190 mounted in my aftermarket frame. I have made it to hooking up the carb. Anyone figured out an easy way to hook up a twist throttle to this engine? Would you use the governor or go straight to carb?
-
I removed the governor, made a mounting plate and hooked it directly to the throttle. I don’t have any good pictures, since I no longer own this bike. Here is the only picture I have.
-
I figured out a bracket. To remove the governor, just take the arm off and leave everything else alone?
-
I seem to remember I removed everything from inside the motor. I think it was a plastic gear and linkage. Getting old sucks , I have a case of CRS. :)
-
I remember talking about that motor with you Rick. Pretty sure that is what you did. Might as well get all those parts out of there! I just did a kart motor and left the arm and all alone and tied it over one way. But if it is for looks remove it!
-
It won’t effect anything to remove arm and ignore the rest? This bike is for wife so all i am really after is dependability. Not even hiding or disguising the engine.