46
Frame, Tank, Seat, Controls, Etc / front suspension
« on: July 20, 2013, 02:25:06 PM »
After riding around I finally found the source of a rattle that's bothered me. It's where the two 3/8" rods with the springs around them, come up thru the plate. I put a couple of plastic bushings in from the spring side to quite it down.(see pic) Originally was there a bushing in it and mine was forgotten by someone, or do they all rattle there? Also, just out of curiosity, why did they use a nut with a little wire sticking out of it on the backside of the front pivot bolt/bushing? Nylock nuts not "invented" yet?