121
Frame, Tank, Seat, Controls, Etc / Re: 1947 Tank Cap
« on: February 07, 2013, 05:46:39 PM »
I saw at least one bike at the Wollard auction that had the cap in place . It is brass . appears it should be smooth across the top surface and knurled on the edge . The bottom is bullet shaped and has a vent hole . The other part of the vent looked to be at the vary top of the threads .
There was an augtion lot that had a couple of the brass ones which were beat up a good bit . In the same lot were some aluminum and possibly a brass home built (machined) caps . I think that lot went for around $50 .
There was an augtion lot that had a couple of the brass ones which were beat up a good bit . In the same lot were some aluminum and possibly a brass home built (machined) caps . I think that lot went for around $50 .