General Category => Frame, Tank, Seat, Controls, Etc => Topic started by: kartjockey on March 29, 2015, 10:55:20 AM
-
This part was missing on one of my frames so had to copy one.
-
I had to replace the pins where the springs ride on the left one because they were rusted some. Turns out they were only pressed in. Some heating with a torch and twisting back and forth with vise grips and out they came!
-
Tom, are the lower legs solid or hollow? If solid, are they drilled to allow the upper piece to just slide in with a press fit?
-
Measures like regular 1/4 pipe. Nearly don't have to drill it to accept upper rods. I took one of these apart to mod my green bike and bottom pieces are made like originals. Tang is .250 thick by .300 wide.
-
Mine are tube...I took the plate off the old one and the bottom inserts...it's much nicer now and I used a brass bushing where it slides threw the plate.....pics soon