46
Simplexes with Non-Original Engines / Re: Torq a verter/ comet clutch metal shroud
« on: September 16, 2014, 09:00:16 PM »
Do ya have an idea of what that kit costs from Wayne?
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
47
Buy, Sell, Trade / Re: foot rest needed!
« on: September 16, 2014, 08:46:53 PM »
Whenever ya take them off, lemme know.
48
Buy, Sell, Trade / foot rest needed!
« on: September 16, 2014, 03:56:32 PM »
i need to track down a foot rest for the right side for my bike... any leads???
49
Simplexes with Non-Original Engines / Re: Torq a verter/ comet clutch metal shroud
« on: September 16, 2014, 10:18:02 AM »
what is the main difference between the TAV and a jack shaft? Is the jack shaft the pic of your bike without the shroud? i'm just looking for the most dependable setup.
50
Simplexes with Non-Original Engines / Re: Torq a verter/ comet clutch metal shroud
« on: September 12, 2014, 09:24:36 PM »
I just sent him a message. Hopefully he'll reply
51
Simplexes with Non-Original Engines / Torq a verter/ comet clutch metal shroud
« on: September 12, 2014, 09:04:47 PM »
Does anybody make a metal cover for torq converters (tav2)?
52
Simplexes with Non-Original Engines / Re: Conversion
« on: September 12, 2014, 12:37:39 PM »
I just picked up my 52 Simplex and want to run an aftermarket engine set up. Any information or recommendations any of you can provide will be greatly appreciated (Pics don't hurt either).
THANKS!
THANKS!
53
Introductions / Re: so cal simplex owner here, needs help!
« on: September 04, 2014, 06:11:39 PM »
Not sure yet. I had a 50 simplex before that used a Whizzer sheave. That was pretty easy. I don't want to use the original wheels that I have, so that means no huge belt around the back wheel. I'm looking to cruise around 35mph, so any suggestions are welcome.
54
Introductions / Re: so cal simplex owner here, needs help!
« on: September 04, 2014, 05:19:31 PM »
So Worksman wheels with drum brakes? Where can I find them? Can I run their drum on the front and rear?
55
Introductions / Re: so cal simplex owner here, needs help!
« on: September 04, 2014, 05:10:58 PM »
I am not going for original. I just want something sturdy. I'm 6'3" and to the scales at 300, so heavy duty spokes are a plus. This is my bike but I don't want to use the original wheels. I also have a 1948 Safti Cycle Cruiser.... all the pics I have of the rolling chassis are too large of file to post.
56
Introductions / so cal simplex owner here, needs help!
« on: September 04, 2014, 03:14:50 PM »
A newbie to the forum, and I need help! I have a 52' servi cycle chassis that I need to get wheels and brakes for. Can anybody on here recommend a wheel and brake combo to use? If you have suggestions it would be GREAT! pics welcome too! Starting from scratch here.