Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Eric

Pages: 1 2 [3] 4 5
31
Introductions / registry
« on: July 18, 2016, 09:09:16 AM »
  Can you please tell me if this is set up so that you can not print it. every time I try it comes up with lines missing so that you can not read it.   eric

32
Introductions / Re: age of my bike
« on: July 18, 2016, 01:20:06 AM »
looking at the registry it does not make cence, frame number go up,  a lot of engine number go down.i did find one frame number just 52 before mine.did engine numbers go in order or did they just take one of the shelf and not bother about the number.

33
Introductions / Re: age of my bike
« on: July 17, 2016, 09:24:59 AM »
Yes I know that, but what range of number would it be for this frame number

34
Introductions / Re: age of my bike
« on: July 17, 2016, 07:33:56 AM »
 As for engine number as I said before it has been ground of ,but i did not know why, I was talking to a gentleman this morning that said he had bought a number of ex usaf vehicles over the years and they all had the engine numbers ground of. must have been something they did when they sold them. we shall never know.  does any one know what range of numbers a 57/58 would come into. I might just stamp  the same number on it as the frame number.the DVLA would accept that because a lot of old british bikes had the same engine number as frame number.

35
Introductions / Re: age of my bike
« on: July 17, 2016, 01:43:23 AM »
 Thanks for this, that would be fantastic.   eric

36
Introductions / Re: age of my bike
« on: July 16, 2016, 01:19:40 PM »
 I did post a couple of pictures on  Simplex  automatic.  who can give me this imformation in writing.  that's the most important part.     eric

37
Introductions / age of my bike
« on: July 16, 2016, 04:27:24 AM »
  To register my bike for the road I need written proof of the age is there any one out there that could do that? the frame number is17090. if not has any one got any ideas how I can get this. the DVLA. need this before they will give me a registration number, and NOVA  the import tax people need it and proof its been in this country over ten years  otherwise I will have to pay import duty on it.     thanks  eric

38
Other Things Simplex / Re: Portland 2016
« on: July 14, 2016, 11:01:23 AM »
  I hope every one going to Portland has a good time ,sounds great. wish I could go somewhere like that.  The only Portland I have been to is the one in  Maine i,used to go there to visit my younger brother, that was until about eight years ago. good luck every body.   eric

39
Simplexes with Non-Original Engines / Re: Simplex Stretch
« on: July 12, 2016, 10:11:32 AM »
  I like it very much. looks good with all the drive on the left.   eric

40
Engine & Transmission / Re: crank nut
« on: July 10, 2016, 07:26:53 AM »
Thank you ,thought it looked like it  but did not want to bugger it up and could not find my thread gauge,  eric

41
Engine & Transmission / crank nut
« on: July 10, 2016, 02:54:17 AM »
  Can any one please tell me what the thread is on the end of the crank, it looks as if mine has been hit with a hammer, and I want to try and clean it up and run a die down it before I try to fit a new nut.when I  get all my new bits.   eric

42
Introductions / Re: Wayne Mahffey
« on: July 05, 2016, 02:59:27 AM »
      Hi  Have done that and sent you a email, hope you get it ok,   All looks to be standard size and in good condition,  cant understand why it was taken apart.    Thanks again   eric

43
Introductions / Re: Wayne Mahffey
« on: July 05, 2016, 01:43:58 AM »
  Hi, Thank you very much for your offer,that would be absolutely fantastic especialy as you don't know me from adam. I will have to go in the garage and strip it as I did not touch it till I knew that I could get the bits for it and get back to you. will go iin there now and do it.    Thank you again  you have made a old man very happy.     eric

44
Introductions / Re: Wayne Mahffey
« on: July 04, 2016, 09:52:41 AM »
 Thanks  Pete, just my luck  will try again   eric

45
Introductions / Re: Wayne Mahffey
« on: July 04, 2016, 09:00:33 AM »
You forget the time difference in the uk to the usa . tried three times yesterday even got up in the middle of the night but got no answer .   eric

Pages: 1 2 [3] 4 5