46
Restoration Projects / Re: RESTORATION PICS
« on: May 05, 2013, 09:16:14 PM »
more pics
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
48
Restoration Projects / Re: RESTORATION PICS
« on: May 05, 2013, 09:07:38 PM »
Here are pictures of the motor progress
49
Restoration Projects / Re: RESTORATION PICS
« on: April 28, 2013, 09:47:32 AM »
I, bolted the springer front end on . I have two projects going so progress is slow.
50
Buy, Sell, Trade / RIMS
« on: April 23, 2013, 10:36:56 PM »
Im still fighting the rim situation . does anyone have a set of 2inch rim hoops in good shape (no flat spots, no major rust) for sale? wayne doesn't have any good ones at the moment. thanks
52
Restoration Projects / Re: RESTORATION PICS
« on: April 20, 2013, 10:06:42 PM »
I have been working on the bike. I pressed in new transmission bearings and have installed new belts. I also had a buddy make a new carriage bracket for the pully, as the old one was bent. I had all the parts powder coated. I then shimmed it all up and mounted it. waiting for more parts too arrive.
53
Other Things Simplex / Re: Where is everyone from?
« on: April 16, 2013, 09:25:06 PM »
Orange county California. Glad to see a few from my area
54
Restoration Projects / Re: 1955 Automatic
« on: April 14, 2013, 05:43:02 PM »
I think the rust looks cool!!!
56
Simplexes with Non-Original Engines / Re: gx200 conversion - rear wheel pulley
« on: April 07, 2013, 08:42:01 PM »
is your old motor still available? thanks, dan
57
Simplexes with Non-Original Engines / Re: Going to ride - with a different motor?
« on: March 31, 2013, 08:52:18 PM »
are parts still available from motor? thanks .Dan
58
Buy, Sell, Trade / Re: CRANKSHAFT SHIM
« on: March 31, 2013, 08:45:10 PM »
Thanks kartjockey, they are #168 on the diagram. not sure how they measure. (very thin though). let me know if you have some. thanks Dan
59
Buy, Sell, Trade / CRANKSHAFT SHIM
« on: March 30, 2013, 11:40:01 AM »
hello, does anyone have three spare crankshaft shims to set up bearing play on a 48" motor? they measure 7/8id 1 1/4 od . its an odd size. they go on either side of rotor valve. thanks. Dan
60
Buy, Sell, Trade / 48 REAR RIM BELT HOOP
« on: March 24, 2013, 11:38:56 AM »
Hello, just wondering if rear rim belt drive hoops are available . if they are what are they going for? not sure if they are all the same, but its for a 1948 with 26x2 rim.
thanks, Dan
thanks, Dan