General Category => Simplexes with Non-Original Engines => Topic started by: Reggie LeGros on October 21, 2017, 10:47:09 AM
-
Hey Guys
I have a Simplex with a Briggs slant engine mounted with a CVT clutch. I would like to mount a Honda GC 190 engine to replace the Briggs. I planning to mount one of
Wayne's kick starters on the GC 190. Wayne says it will fit. I am asking anyone with knowledge on mounting the GC 190 to give me advise and guide me along the way.. I will appreciate any advise you can help me with this project.
Thanks
No Shift
-
Reggie, read my thread on the stretch that I built. I used a GS190 motor, which is the same dimensionally as a GC160. I modified one of Wayne's kick starters to work with it.
-
Hey did you check out my bike with the gc190 on it. I went all out and I even dropped the carb down about 6inches to make room for the transmission.
-
F you check out the 56 with a Honda cg190 and first roll out. I tried to give as much detail as possible on my use of the gc190 motor and the problems I encountered. Post as many photos as you can.
-
Hey Oil Lamp
I cannot get any pictures of your bike. I would appreciate you sending me the photos of your rebuild to guide me along. My email is as follows: grochein@aol.com.
Thanks
No Shift
-
That is because Matt, who started this build did not host his pictures here, but used photobucket.
http://www.simplexservi-cycle.com/index.php?topic=669.105
In this thread, starting on page 8, is when Reese took over. He did host his pictures here, so all of his modifications are still shown.
Did you check out my build with the GS190 and Wayne's kick start? I put up a pretty detailed history how it can be done.
-
Hey Guys
Thanks for the replies. I am searching you all's threads to get all the information I can. The photos are extremely helpful. I am sure I will be asking more questions as I go along.. Just received my new Honda GC 190. At this point the bike is apart and being sanded to be painted. The conversion should go smoothly being that everything was done except changing the motor out and the painting.
Reggie "No Shift" LeGros
-
Reggie I will get some pictures sent to you as soon as I can. If you have Wayne's jackshaft and kick starter you have almost everything you will need. If you are wanting to put the transmission up under the seat as I did you will need a longer belt. I would take some current photos but I have mine taken apart trying to rework the brake system. With the GC motors you need a different way to brake. Rick moved his pedal down I'm working on a cable system.
-
My 45-50 mph GC190 Simplex.
-
Very nice build. Where did you get the front wheel?