General Category => Other Things Simplex => Topic started by: kartjockey on June 29, 2018, 05:25:27 PM

Title: A New Look!
Post by: kartjockey on June 29, 2018, 05:25:27 PM
Finishing up my trailer to go down the road in style.  Sand blasted and painted.  Added hooks for ratchet straps.  Screw eye at rear is removable and aids to not have to cross over straps when hauling two bikes on board.  Cut off old fenders and changed over to bolt-on ones that actually do the tires justice.  Had to have decals sized down to fit accordingly.  Stainless hardware everywhere.  Contacted the manufacturer in Georgia whom sent me a replacement VIN sticker at no charge.  LED lighting with sealed trailer plug. CNC burned and bent the spoiler today and just brought it home for a trial fit.  Hopefully I can get it under paint in the next few days.  It is easily removable.
Title: Re: A New Look!
Post by: pd on June 29, 2018, 07:28:07 PM
Nice work , Tom .

I don't know any Simplex bikes that would say no to being toted on that trailer . ;)

Pete . :)
Title: Re: A New Look!
Post by: Ricks on June 30, 2018, 05:03:12 AM
Rolling in style Tom!
Title: Re: A New Look!
Post by: Bob53 on June 30, 2018, 06:10:25 AM
Pretty snazzy Tom. The green bike and the new step through will be riding in style.
Title: Re: A New Look!
Post by: kartjockey on July 01, 2018, 06:03:26 AM
Boy!  I love this guy.  I had to put a slight bend in one of the uprights to compensate a bit of twist in the rail around the trailer.  I acquired this set from my Dad but never tried it. But remember him saying "MAPP gas gets hot".  That it does! The oxygen tank has a working regulator and makes for a precise flame that can be pin pointed for nice bends or whatever is needed.  
Title: Re: A New Look!
Post by: Ricks on July 01, 2018, 07:21:39 AM
I remember my grandfather had one of those Mapp/oxygen torches also.  I see you used the newer Map/Pro gas that replaced the real Mapp in 2008.  I had read that some people didn't think it worked as well, but you seem to have proven them wrong!
Title: Re: A New Look!
Post by: pd on July 01, 2018, 07:50:51 AM
I've been using mapp gas for years . It gets a lot hotter than just propane , for sure .
Never tried the combination though . Might have to try it sometime .

Pete . :)
Title: Re: A New Look!
Post by: Ricks on July 01, 2018, 07:57:48 AM
I've been using mapp gas for years . It gets a lot hotter than just propane , for sure .
Never tried the combination though . Might have to try it sometime .

Pete . :)

Pete, do you still have some Mapp gas left or are you using the newer Map/Pro?
Title: Re: A New Look!
Post by: pd on July 01, 2018, 09:21:17 AM
I've been using mapp gas for years . It gets a lot hotter than just propane , for sure .
Never tried the combination though . Might have to try it sometime .

Pete . :)



Pete, do you still have some Mapp gas left or are you using the newer Map/Pro?

Rick ,

Pretty sure I still have a little left . The bottle is getting light , so there's not much in there . Been meaning to pic up a fresh one .
I didn't know there was a change like you mentioned . What's different and how much difference from old to new ?

Pete . :)
Title: Re: A New Look!
Post by: Ricks on July 01, 2018, 09:24:57 AM
I've been using mapp gas for years . It gets a lot hotter than just propane , for sure .
Never tried the combination though . Might have to try it sometime .

Pete . :)



Pete, do you still have some Mapp gas left or are you using the newer Map/Pro?




Rick ,

Pretty sure I still have a little left . The bottle is getting light , so there's not much in there . Been meaning to pic up a fresh one .
I didn't know there was a change like you mentioned . What's different and how much difference from old to new ?

Pete . :)

I don't know much, I just googled it.  I went to buy a new bottle of Mapp a couple years ago and all Home Depot had was Map-Pro.  I used it without O2, and it seemed down on heat compared to the old Mapp I ran out of.
Title: Re: A New Look!
Post by: kartjockey on July 01, 2018, 09:52:15 AM
I heated 1 1/4 rect. tubing 11 ga. wall to red on all four sides in no time then bent it as needed.
Title: Re: A New Look!
Post by: pd on July 01, 2018, 09:56:16 AM
OK .
I just went out and checked my bottle . It says Mapp Gas . But below , in small print , it says something about 'stabilized' . There was nothing like Mapp/Pro on the label .

Just read the Wiki ( https://en.wikipedia.org/wiki/MAPP_gas ) .
Original , un-stabilized , MAP gas was MAPD .
And , true , there is a temperature difference .

So , what I have is the stabilized version .

Which ever , I definitely prefer it over propane .
Like I said , I'll have to try it with O2 sometime .

Pete . :)
Title: Re: A New Look!
Post by: Ricks on July 01, 2018, 10:06:07 AM
I heated 1 1/4 rect. tubing 11 ga. wall to red on all four sides in no time then bent it as needed.

That’s good to know!  I’ve considered buying an oxy/acetylene a few times but don’t like the idea of acetylene in the garage. Tom, thanks for the report!
Title: Re: A New Look!
Post by: butch27 on July 08, 2018, 10:04:36 AM
Super nice trailer