1
Frame, Tank, Seat, Controls, Etc / Seat bar
« on: September 29, 2018, 06:04:20 PM »
What year or models had seat bar straight like these? My other simplex's have the bar curve down the frame then come straight out
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Other Things Simplex / 48 exhaust
« on: September 26, 2018, 09:16:22 AM »
Anybody got pics of what the exhaust and muffler look like on a 48?
3
Other Things Simplex / Late model automatic
« on: August 19, 2018, 06:11:10 PM »
Hey yall hadnt been on here in a while but I was wondering what yall know about a late model 150cc with flat fenders,bulkier springer and 24" wheels?
4
Buy, Sell, Trade / magneto cover
« on: February 19, 2014, 04:52:53 PM »
Does anybody on here have a magneto cover for sale?
5
Engine & Transmission / Motor wont run
« on: April 23, 2013, 06:09:35 PM »
Need a little help here! I'm trying to run my motor for first time and I have good spark and fuel but cant get it to pop off while turning motor with a drill
6
Engine & Transmission / Oil/gas mix?
« on: April 17, 2013, 05:49:07 PM »
I am about to run my motor for the first time and figured I'd ask yall how should I mix oil and gas till broken in
7
Engine & Transmission / clutch bracket
« on: March 11, 2013, 12:25:27 PM »
Hey yall I got another question. Does the automatic clutch bracket bolt to the outside or inside of the frame? Ive looked at several pics of bikes on here and some are to outside and some are to inside,and also should I put a flat washer between clutch bracket and frame?
8
Other Things Simplex / kicker
« on: March 09, 2013, 03:25:15 PM »
Hey yall,I put all new rivets in my kicker but the back hole was hollowed out 2-3 times the amount of other holes so I pressed a piece of steel in it and was going to redrill it. I read on here one of yall said it is supposed to be bigger than the other holes so how much bigger before I drill it wrong?
9
Engine & Transmission / Stud
« on: February 20, 2013, 07:15:25 AM »
Hey yall,What size and thread is the stud on the top of the cylinder that goes to the motor mount bracket?
10
Engine & Transmission / Carb
« on: February 06, 2013, 09:02:19 AM »
Just figured I would pick yalls brains a little bit. Will any Tillotson MT carb work with my motor and what model # is original to the M motor? I have a Tillotson MT 57a and don't have a carb for my dads bike but have a few old cushman scooter motors with carbs
11
Other Things Simplex / servi cycle fender tip
« on: December 04, 2012, 12:27:30 PM »
Let me start off by saying hey yall I just joined this site. My dad and I are building a couple of Simplex's and and I am on the search for a fender tip. I asked Wayne about it and he said a guy in florida used to make them but he died a little over a year ago and I was wondering if any of yall have or know someone who has one of these fender tips for sale.I would appreciate any help,Thanks
Pages: [1]