General Category > Simplexes with Non-Original Engines

Twist throttle to gs190

(1/2) > >>

razerface:
I have the gs190 mounted in my aftermarket frame. I have made it to hooking up the carb. Anyone figured out an easy way to hook up a twist throttle to this engine? Would you use the governor or go straight to carb?

Ricks:
I removed the governor, made a mounting plate and hooked it directly to the throttle.  I don’t have any good pictures, since I no longer own this bike. Here is the only picture I have.

razerface:
I figured out a bracket. To remove the governor, just take the arm off and leave everything else alone?

Ricks:
I seem to remember I removed everything from inside the motor. I think it was a plastic gear and linkage. Getting old sucks , I have a case of CRS.  :)

kartjockey:
I remember talking about that motor with you Rick. Pretty sure that is what you did.  Might as well get all those parts out of there! I just did a kart motor and left the arm and all alone and tied it over one way.  But if it is for looks remove it!

Navigation

[0] Message Index

[#] Next page