General Category => Frame, Tank, Seat, Controls, Etc => Topic started by: Scooter4 on May 10, 2024, 04:55:55 PM
-
Good evening,
Will someone please measure the wire diameter to make retaining ring for round taillight? I made one and used too small of diameter and lens can still shake out so I thought I would ask before I make another one.
Thank you,
Scooter
-
Measures .092" So right at 3/32". Laying free the diameter is about 3 5/8" with 3/4" between the tails.
-
Also has the extra little bend to stick a pick into so you can get it out of the groove easier.
-
I figured it needed to be thicker. Mine is .06". I will make a new one.
Thank you for the picture and measurements.
Scooter