« previous next »
Pages: 1 2 [3]   Go Down

Author Topic: Crank bearing inside the Mag plate M engine  (Read 6835 times)

pd

  • Hero Member
  • *****
  • Posts: 3130
    • View Profile
Re: Crank bearing inside the Mag plate M engine
« Reply #30 on: August 14, 2013, 09:14:31 AM »
Being as I have not replaced that bearing , I was speculating .
I was just taking the case bearing mount method as being 'common' to the manufacturer .
It's good to know that heat is not needed .

Pete . :)
Logged
Goes around , Comes around . :)

old servi

  • Newbie
  • *
  • Posts: 41
    • View Profile
Re: Crank bearing inside the Mag plate M engine
« Reply #31 on: August 15, 2013, 05:58:13 PM »
I have ordered a couple of the 5203 bearings. Should have them by Monday.
If the bearing is 17MM will have a gap of 8MM after it is set into the mag plate.
from the end of the cam to the edge of the pulley is 25MM on this engine.
Logged

pd

  • Hero Member
  • *****
  • Posts: 3130
    • View Profile
Re: Crank bearing inside the Mag plate M engine
« Reply #32 on: August 16, 2013, 08:15:52 AM »
Here's a pic of the clearance between the back of the mag plate and the drive pulley ( Phelon magneto ) :

Logged
Goes around , Comes around . :)
Pages: 1 2 [3]   Go Up
« previous next »