« previous next »
Pages: [1]   Go Down

Author Topic: Repro springer  (Read 2582 times)

kartjockey

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1669
    • View Profile
    • Email
Repro springer
« on: March 29, 2015, 10:55:20 AM »
This part was missing on one of my frames so had to copy one.
Logged

kartjockey

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1669
    • View Profile
    • Email
Re: Repro springer
« Reply #1 on: March 29, 2015, 12:01:20 PM »
I had to replace the pins where the springs ride on the left one because they were rusted some.  Turns out they were only pressed in. Some heating with a torch and twisting back and forth with vise grips and out they came!
Logged

Ricks

  • Administrator
  • Hero Member
  • *****
  • Posts: 3633
  • 1953 Automatic
    • View Profile
    • Email
Re: Repro springer
« Reply #2 on: March 29, 2015, 12:20:19 PM »
Tom, are the lower legs solid or hollow?  If solid, are they drilled to allow the upper piece to just slide in with a press fit?
Logged
Rick

kartjockey

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1669
    • View Profile
    • Email
Re: Repro springer
« Reply #3 on: March 29, 2015, 12:46:02 PM »
Measures like regular 1/4 pipe.  Nearly don't have to drill it to accept upper rods.  I took one of these apart to mod my green bike and bottom pieces are made like originals.  Tang is .250 thick by .300 wide.
Logged

Bruce

  • Sr. Member
  • ****
  • Posts: 382
    • View Profile
Re: Repro springer
« Reply #4 on: April 16, 2015, 08:15:21 AM »
Mine are tube...I took the plate off the old one and the bottom inserts...it's much nicer now and I used a brass bushing where it slides threw the plate.....pics soon
Logged
Pages: [1]   Go Up
« previous next »